86 ford eec iv pinout diagram3/2/2024 ![]() 4-Speed Auto Transmission Control via 6 On/Off Solenoids, and 1 Variable pressure Solenoid The EBII-ED 4.0i EEC-IV Module has the following features, Is located on the top Row, Far Right, when the wiring connector is connected to the EEC-IV Module. The EBII-ED EEC-IV Wiring connector is the Standard Ford 60 Pin Connector, as used on the XF 4.1 EFI, EL EEC modules. 4 Finally slide the kick panel backwards towards the back of the car.3 Pull the back of the kick panel towards the transmission, to disengage the kick panel from the chassis.2 Remove the plastic plugs used to secure the plastic kick panel. ![]() 1 Remove the 3 Retaining screws on the plastic door scuff plate, and remove the scuff plate.To remove the kick panel, and gain access to the EEC-V module, you will need to complete the following. The EEC-IV Module is located behind the Left Hand Side Kick Panel, On the passenger side of the vehicle, near the front seat. The above image describes the EEC-IV module Pin numbers, that are used on the Powertrain Control module. The information includes wiring connector pin-outs, wire colours, expected voltages, and wire feature. This document describes the pinouts, and wiring for the EEC-IV Engine and Powertrain Control Module, for the EL 6 cylinder FORD FALCON EBII & ED 4.0L 1993-94, FORD FAIRLANE NC & NCII, LTD DC & DCII 1993-94, XG Utility and Van 1993-96 Model Falcons Ford EBII - ED Inline 6 EEC-IV Wiring Information
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |